There are 7500 types of power tool holders that can be used in almost all CNC lathes with different transmission requirements. Engineers will provide ambitious solutions based on any customer requests. In addition, we also provide customers with a modular VDI/BMT servo power turret system, mainly used in CNC lathes and turn-milling composite machine tools, and optimize the design based on the internal space of the customer's lathes.

What do you need to pay attention to before working on the power cutterbed? Below is a brief introduction by the editor of this article, hoping to assist everyone.

1. Admit that the main intake supply pressure is within the range of 0.5~0.6Mpa. If outside the scale, please adjust to within the scale.

2. Please check if there is any air leakage at the joint of the power cutterbed of each pipeline drilling machine. If there is any air leakage, please tighten it or replace it with a new component.

3. Admit if the protective cover is installed and may be damaged. When not installed, please install in the correct position. If damaged, please replace it.

4. Admit whether the setting of the current value of the electromagnetic concentrator switch is accurate. If it is outside the rules, please set it again.

5. Please check if there is any oil leakage in the hydraulic damper. If there is an oil leakage, it needs to be replaced or repaired.